In this case, use a hacksaw blade to cut the nut off. Some nuts are however too corroded and even after using a penetrating oil it won’t loosen.If on the other hand the whole bolt is swiveling, use a long screwdriver to hold it from inside the toilet tank while you loosen the nut below with the wrench.If the nuts looks corroded or are just too tigh40t, spray then with a penetrating oil like WD-40 and wait for 15 minutes before attempting again.Using an adjustable wrench, loosen the nuts attaching the tank from underneath the bowl.To remove the toilet tank proceed as follows: The toilet tank is attached to the toilet bowl using 2 or 3 long bolts that run through the inside of the tank and are tightened from underneath the toilet bowl using nuts and washers. It is always advisable to loosen its coupling using your bare hand first before attempting with a wrench. It is connected to the fill valve from underneath the toilet tank. The Water supply line is a stainless steel braided water line that is connected from the shut off valve to the toilet tank. Use the sponge to soak it and squeeze into the empty bucket.

At the bottom of the tank, you will find some water which was not flushed down.Remove the toilet tank lid and place it away.Flush the toilet and hold down the handle to make sure as much water as possible has drained out.In this case, pull the valve handle outwards. Some toilets however have a push/pull valve. It is mostly located on the left-hand side.

To turn of water to the toilet, locate the shut off valve at the rear wall of the toilet close to the floor. Materials Needed to Install a Toilet Tank Installing a toilet tank involves the following steps: The tank is then attached to the water shut off valve using a supply line.īefore installing a toilet tank, you may need to remove the old tank first. Each bolt is backed up by metallic and rubber washers to avoid leaks and wobbling.Ī toilet tank to bowl gasket is also installed on the outside of the flush valve to prevent the toilet from leaking between the tank and the bowl. Toilet tank are are mounted on top of the toilet bowl using 2 and sometimes 3 bolts. If that is your situation, I will show you how to remove and install a toilet tank.

If you have a two-piece toilet, chances are that you might at some point want to replace the toilet tank and not the bowl.

How to install toilet tank bolts